What are the common problems of automatic oil press and how to solve them?
More and more customers buy automatic oil press, but the structure and technology of automatic oil press are complex, and the problems make many old customers feel confused. According to the technical maintenance personnel, multifaceted summary of automatic oil pressing opportunities which common problems and solutions:
Automatic oil press in use suddenly stop running; And the solution: the press chamber may not be heated into a large amount of oil; Maybe the oil cake is too thin and the pressure of the pressing chamber is too high. The cake is too dry when running in.
The frame of the automatic oil press is damaged; And the solution: may be the oil press inside the shaft card, forcing the reversal of the mandrel. When the shaft is stuck, the manpower is forced to reverse the triangle belt.
The press cage of the automatic oil press breaks suddenly; The cause of this problem: too much oil may be put in at the beginning of the press. Metal, stone and other sundries into the press chamber of the oil press. Pressing too many times during pressing and not adding enough water to the material. It is possible that the press chamber in the oil press has not been cleaned or the debris has not been cleaned before forcing the material into the press.
Automatic oil press does not work: current impassability or short phase check current and phase; Control box electrical damage cut off the power supply, replace electrical; Enter the hard material into the raw material to open the lower funnel plate, close the upper plate, press the reverse switch, pour out the foreign body; The oil cake adjustment is too thin. Turn the adjustment handle 1-2 times clockwise. Spindle key out of the spindle check; Press chamber temperature is low.
Low oil yield of automatic oil press: too thick or too thin oil residue cake. Adjust the thickness of oil residue cake; If the raw material is heated too high or too low, the magnetic material will be cooled or heated to an appropriate temperature; Machine temperature is too high or too low machine temperature adjustment suitable temperature; Low oil content of raw materials or impurities are too large to select raw materials and dry treatment; Vacuum pump to remove and adjust the thickness of the slag cake.
