What faults can occur in the use of hydraulic oil press?
What faults can occur in the use of hydraulic oil press? How to solve it? Follow us today to find out.
If something is sucked into the pump, the ball in the inlet valve cannot be restored to its original position. The solution is to clean up the debris in the pump and replace the clean hydraulic oil.
Air in a low pressure pump. The solution is to remove the gear pump tubing, start the oiler, pump oil from the tubing, and reset.
The oil seal in the hydraulic cylinder is damaged. Solution: Replace the oil seal with new one. Leak oil, loosen joint seal. The solution is to replace the fire engine with a new seal ring and tighten the bolts.
The pump piston is badly worn. Solution: Replace it with a new piston.
When we use a hydraulic oil press, there will be no pressure boost, which is generally caused by these reasons.
First of all, sundries are sucked into the oil pump, so that the steel ball in the oil inlet valve can not be restored to the original position; This requires attention to the maintenance of hydraulic oil press, and regular filtration or replacement of hydraulic oil. There is air entering the low pressure pump, which belongs to the operation error. It is necessary to remove the gear pump tubing, and then start the hydraulic oil compressor. Drain the oil line and reset it.
The oil seal damage in the oil cylinder is generally caused by long-term wear and tear, and only a new oil seal can be replaced.
