Troubleshooting method of automatic oil press machine
How to use automatic oil press to extract good oil? Learn to troubleshoot first, a question many users ask. Let us fully automatic oil press to share for you.
Remove oil edge from sieve
During the inspection, if the screen surface is not level level, the length of the left and right arms should be adjusted. If the sieve is twisted, the eccentric axle is perpendicular to the frame. If the surface oil of the stone mesh is single, the level of the frame can be adjusted; If the air flow is not uniform, the frame adjustment plate can be adjusted to make the air flow evenly blown into the screen. If the network cleanliness rate is low, replace the brush with a new one or adjust the brush length and plane tilt Angle.
The belt oil won't lift
The main reason is that the lower part of the bucket lift conveyor is too much oil, blockage, open the lower part of the conveyor door, clean up the oil.
Uneven steaming in the pot
During the inspection process, when the steam nozzle of the steam dryer is blocked or rusted, the steam nozzle should be dredged. If the middle is the bottom of the blank tank, the distance between the scraper and the bottom of the tank can be adjusted; If the scraper is twisted and worn, please be sure to replace the scraper; If the billet is not evenly steamed and fried, the limit switch, contacts and float plate should be adjusted to coordinate their work.
The drum will not rotate under overload
The elimination methods are as follows: when starting, there is oil between the drums, loosen the adjusting bolt between the drums, remove the oil between the drums; The feed quantity is too large and the speed is too fast. When the thickness of the inlet barrel is not uniform, the clearance of the drum should be adjusted again and the loose nut should be tightened.
The quality of the automatic oil press depends on the amount of oil delivered. There are many factors that determine how much oil is produced. Automatic oil press itself, pressure and temperature of the chamber are the main factors affecting the performance of automatic oil press. Automatic oil press cycle operation, oil line clearance 150 wire, slag amount is large, reduce the pressure of the pressure chamber, reduce the amount of oil, ensure the pressure of the pressure chamber and yield. Electronic temperature control technology is adopted to ensure the appropriate oil transfer temperature in the pressure chamber and timely control the pressure temperature required by different oils.
