In fact, feed pellet machine can process a variety of raw materials including corn and bran, and keep the original ratio. If the proportion of roughage in the feed formula is large, it needs to be adjusted appropriately to avoid too much powder in pellet feed. The recommended ratio is 3:2 of concentrate feed and roughage.
Feed pellet machine is not only suitable for pelleting of single raw materials, but also for pelleting of multiple raw materials together. During operation, the raw materials are crushed first and then mixed evenly, so that the pellet feed made in this way is more nutritious and more palatable.
No water and additives are needed when using feed pellet machine. Viruses and bacteria in feed will be killed by high temperature treatment, so no additional addition is required. At the same time, the moisture content of feed made by feed pellet machine is controlled at about 10%, ensuring that it is dry and not easily affected by moisture.
| Model | Capacity | Power | Dimension |
| 125 | 80-100kg/h | 3kw | 110*35*70 cm |
| 150 | 120-150kg/h | 4kw | 115*35*80cm |
| 210 | 200-300kg/h | 7.5kw | 115*45*95cm |
| 260 | 500-600kg/h | 15kw | 138*46*100cm |
| 300 | 700-800kg/h | 22kw | 130*53*105cm |
| 360 | 900-1000kg/h | 22kw | 160*67*150cm |
| 400 | 1200-1500kg/h | 30kw | 160*68*145cm |
What is the installation and debugging method of feed pellet machine?
Before installing feed pellet machine, you need to be familiar with the process flow of production line and the functions of each equipment. Before debugging, check the running status of equipment one by one to ensure that the crusher matches the pellet machine.
The recommended particle size distribution is as follows: ≤1% above 3.35mm, ≤5% above 2.0mm, about 20% above 1.0mm, about 30% above 0.5mm, not less than 20% below 0.25mm, and about 24% above 0.25mm.
Before commissioning, clean the equipment and remove the debris left during installation. Ensure that the steam pipe system has decompression and drainage functions to provide dry saturated steam. Before starting the pelletizer, adjust the distance between the roller and the ring die to the optimal state, usually 0.1~0.4MM.