Pellet machines, straw pellet machines, biomass pellet machines, sawdust pellet machines, etc., when using pellet machines, it is inevitable that there will be some small faults. Here's how to solve them:
1.After the pellet machine produces pellets, it is found that the surface of the pellets is uneven or even there are too many wounds on the pellets. This problem indicates a problem with the blades inside the pellet mill. If the blade is intact, the resulting particle surface is very smooth and almost the size. Both are relatively common.
2. The surface of the particles is too smooth, which is also a problem, which can explain that the mechanical hard material is too high, the compression of the ring die is relatively small, and the compression hole should be increased. This phenomenon is relatively rare, and this problem is rarely encountered. However, It is necessary to avoid it as early as possible. The first thing to do is to check the raw materials before construction to see if there are hard objects, etc. This is very important.
3. When the water content of the particles is too high, the phenomenon of blocking the machine often occurs. So we try to construct after testing the moisture of the pellets. If the moisture is too high, we should dry it or dry it and try to avoid using it when it is wet. This will increase the load on the machine and affect the normal operation of the pellet mill.
4. The machine itself has cracks on the granulator. This phenomenon is very obvious. Generally, the granulator can be heard from the sound. The granulator will make a lot of noise during operation, or the noise is very loud. is an error, so we're going to stop running the check. After the pellet machine is put into use, we often encounter problems with the quality of the machine itself. Most of the reasons are caused by the long-term use of customers. So we should pay attention to this when running the pellet machine.