The gap between the pellet machine pressure wheel and the grinding disk is too large, which may also be one of the reasons for the pellet machine not to discharge the material, the method of adjusting the gap between the pressure wheel and the grinding disk, twist the pressure wheel with one hand, adjust the corresponding bolts, and adjust the pressure wheel to both sides of the pressure wheel with force to shake not move, a little bit of a tight state, that is, it is a sign that the pressure wheel and the grinding disk have been adjusted in place.
These reasons may be caused by the basic reasons for the grain, the face of the feed pellet machine often appear problems, we solve the method is also very simple, first of all, we have to optimize the grinding hole, let it work for a period of time to adapt to the environment did not then can be solved, if the feed is too much moisture, then can only be dried in the sun, if the moisture is too little need to add the right amount of water, only the raw material to maintain a certain moisture, the drying and ripening of the pellet machine. Only when the raw material is kept at a certain moisture level, the drying and maturing function of the pellet machine can be played to, and the pellet machine can be very smooth.
