Briquette Machine With Screw Propeller

Tianjin Mikim Technique Co., Ltd. is one of the most experienced manufacturers and suppliers of briquette machine with screw propeller in China. If you're going to buy cheap briquette machine with screw propeller made in China, welcome to get more information from our factory. All our products are with high quality and low price.

Briquette Machine With Screw Propeller

briquette machine with screw propeller is a kind of hot sell briquetting machinery. Based on years of manufacturing experience, both the structure design and appearance design are improved greatly. is capable of making sawdust briquettes.

Parameters of briquette machine with screw propeller

Wood Briquettes:

1) This bio-fuel briquette is 30-80mm in diameter, occurs in the hollow quadrangular or hexagonal cylinder or hollow hexagonal with a 15-20mm inner-hole.

2) The available shape: square, hexagonal, pentagon, pentagon with edge, hexagon with edge

3) The available diameter could be: 50mm,55mm.60mm,65mm.70mm.80mm and so on

4) The available length could be: 20cm,30cm, 40cm, 50cm

5) Final Briquettes: Specific gravity: 1300-1900kg/m; Calorific value: 4500-5000kcal/kg

Production step --briquette machine with screw propeller

1)fastening bolts, especially in the heating barrel set of three top wire, connecting and electrical power lines.
2)check bearing lubrication part.
3)check the supply voltage is normal.
4)no-load starting running 30 minutes, no card, touch the abnormal phenomenon, can be put into normal production.When the trial revealed abnormalities, should immediately stop, find out the reasons, troubleshooting and then makes no-load operation.
5)the temperature regulator adjusted to the required temperature, when the temperature reaches a predetermined temperature before starting, and amount of feed.
6)gradually increased feeding rate, until the production of qualified products, produced when the normal 30 minutes, can show trial run is successful, the normal operation of.
At the end of 7 to make the hopper feeder with no raw material , and after shutting down the machine immediately reversed for 1 minutes, so that the propeller material would be exit.

Hot Tags: briquette machine with screw propeller, China, manufacturers, factory, cheap, low price, made in China, Sawdust Briquette Extruder, Briquette Making Machine, Charcoal Briquette Making Line, Biomass Briquette Machine, Small Briquette Pressing Machines, Charcoal Briquette Machine