Check the fasteners before starting the feed puffing machine, there shall be no loosening. Make sure the steam and water can be supplied normally. Make sure the power supply and electrical appliances are normal. Open the steam valve, preheat the puffing chamber, the temperature is about 100 degrees. Begin to start the equipment: start the tempering device, start the feeding winch, tempering device outlet material outflow, start to add steam to the tempering device, when the material is tempered, open the main motor, add a small amount of water to the puffing chamber, while feeding the material into the puffing chamber, when the material is extruded, adjust the puffing effect of the product and moisture and so on.
After the end of production (i.e., there is still material in the raw material warehouse), we need to stop the machine, and the stopping order is: feeding winch, tempering device. Then wait until the host current indicator value on the electronic control cabinet becomes no-load current value, will be the main motor, oil pump motor stop, (corn puffing, should be in the first section of the puffing chamber of the bypass feeding port feed about 25 kg of soybean meal to clean the residual corn material in the puffing chamber, and then only stop the main motor, to prevent blocking the machine).
