When installing the bearing of the wood pellet machine, do not install too hard, otherwise it will cause the wood pellet machine to slip in the pelletizing operation. A better way to solve this is to always pay attention to the finale of the roller, even if it is replaced with a new roller. When we use the wood pellet machine for work, if the gap between the pellet machine's pressing shafts is not well controlled, it is easy to produce particles that are not uniform in the pelletizing process, and the output is too small, and the pellet machine cannot be pressed. Press the material tightly, so that it is easy to cause the pressure shaft to slip.
A better way to solve this is to reduce the distance between the two main shafts of the pellet machine. In addition, when the raw materials are pressed with a wood pellet machine, the raw materials contain too much moisture or the steam generated when passing through the wood pellet machine is large, which will cause the lubrication of moisture when the wood pellet machine is operated. It will cause the pellet machine's final shaft to slip.
A better way to solve this is to reduce the amount of steam in the raw materials and keep the amount of water contained in the materials within a reasonable range. The use of the wood pellet machine for a long time will cause the wear of the final shaft (a basic type of component failure), which will cause the final shaft to slip and fail to work normally. A better way to solve this is not only to keep the cleaning of the wood pellet machine from time to time, but also to replace the new roller at any time.