Usually, when we use the wood pellet machine, the lubrication system inside the equipment is an indispensable part of the entire production line. If there is a lack of lubricating oil during the operation of the wood pellet machine, the wood pellet machine cannot operate normally. Because when the wood pellet machine is in operation, the pressure is very huge, because when making pellets, the friction between the raw materials will generate a lot of heat, which will lead to high temperature and deformation of the equipment. Just tell you what are the requirements for the emergency bearing lubrication of the wood pellet machine when producing pellets: Generally speaking, the raw materials used in the wood pellet machine produced by our factory are eucalyptus, birch, poplar from nature. , fruit wood, wood chips, branches, etc. are used as raw materials for making pellets. At the same time, the sawdust pellet machine can effectively solve the problem of difficulty in pelletizing crude fiber raw materials, and can customize the molds for various pellet machines so that the life of the equipment can be extended. At the same time, it can improve the quality of pellets and reduce the excessive consumption of raw materials.
In this regard, we should pay attention to learning what the emergency bearing lubrication requirements of the sawdust pellet machine are during the production and operation of the sawdust pellet machine:
1. When the wood pellet machine runs continuously for 4 hours, it is necessary to lubricate the pressing roller of the equipment at least once. It is also recommended to give a small amount of lubrication every 1 hour of operation (add butter to the rolls at the end of each process to prevent material from entering. The butter in the rolls shrinks as it cools, pulling the material into the bearing).
2. Lubricate the spindle bearing of the sawdust pellet machine every 8 hours.
3. When the wood pellet machine works for 2000 hours, or every 6 months, the gearbox oil should be changed.
4. Check the oil level of the feeder drive on time every week, and add a little oil to the roller chain drive. Fifth, strengthen the lubricating oil for the conditioner of the wood pellet machine and the bearing of the feeder shaft once a month.
5. It should be noted that the cutter frame of the sawdust pellet machine should be lubricated once a day, and it is recommended to lubricate it manually in order to make the operation more convenient.
