Disc Branch Crusher

Tianjin Mikim Technique Co., Ltd. is one of the most experienced manufacturers and suppliers of disc branch crusher in China. If you're going to buy cheap disc branch crusher made in China, welcome to get more information from our factory. All our products are with high quality and low price.

Tree shredder
Disc wood chippers have many advantages .Better chip quality results from the stable feeding and chipping action-a result of less movement in the spout.Minimal pins and fines are generated with the accurate knife-to-anvil adjustment.No damage to the chips on exit through the clear discharge path, minimizing pins and fines.

Replaceable wear plates on the chipper disc surface.Factory installed knife style options include conventional Babbitted knives, and commercially-available disposable knife systems.Reduced maintenance man-hours-most knife changes can be handled by one man from the front of the chipper disc.

Outstanding bearing life results from hollow shaft, fixed arbor design.Sizes from 52″ to 84″ disc diameter available.Uniformly sized conventional pulp chips as well as mini- and macro-chips.

Industrial wood chipper

Electric chipper shredder
1. The wood chipper should be fixed on the ground and can be fixed with cement.
2. When the wood grinder starts to run, pay attention to whether there is any debris on the wood grinder. When the wood grinder is tested, check whether it is inverted, put less material, and see whether the quality of the finished product meets the standard. When the wood grinder customer buys it home and installs the test machine, put the wood in. Try to wait until the previous piece of wood enters the feed port before putting the second piece in to avoid jamming the machine.
3. The wood grinder should be fed evenly. If there is any noise, the bearing and body temperature is too high, or it splashes outward, stop the machine immediately to check and troubleshoot.
4. Before starting and shutting down the wood grinder, check the circuit to avoid leakage. The length of the wood must be moderate, not too long, preferably less than 30 cm, and not too thick. The discharge port and feed port should be as spacious as possible to avoid some accidents.

Garden chipper

Wood chipper shredder
1. The disc crusher should be placed on a stable platform
2. Open the upper cover of the crushing chamber, put the crushed material into the crushing chamber, and then tighten the upper cover.
3. Turn on the switch, the equipment starts to work normally, about 2 minutes, turn off the switch, open the upper cover to take out the crushed material, if the crushed material does not meet the fineness requirements, restart the machine.
4. The amount of crushing at one time should not exceed the specified requirements to avoid overheating of the motor due to excessive load and affect the service life. The crushed material must be kept dry, and it is not suitable to crush wet or oily items.
5. Each crushing time is less than 5 minutes, and the interval is 3 minutes before continuing to use.
6. When replacing the blade and carbon brush, you should pay attention to cutting off the power supply and tightening the screw, and check whether the components are loose at any time.
7. Before opening the cover of the crushing chamber, you should pay attention to cutting off the power supply, and it is strictly forbidden to start with the cover open.
8. After use, the crushed material should be cleaned up in time and kept dry and clean.

Qualifications and Honors

Hot Tags: disc branch crusher, China, manufacturers, factory, cheap, low price, made in China, chipper shredder, disc chipper, tree branch shredder, wood chipper, electric wood chipper shredder, garden chipper mulcher