Broken
pulp, juice and peel enter the coconut juice extractor through the
hopper, and the screw pitch decreases with the gradual increase of the
diameter at the bottom of the spiral in the direction of the residue
outlet.When the material is pushed forward by the screw, the volume of the
spiral cavity decreases, forming the extrusion of the material.
The spiral spindle rotates clockwise from the feed hopper to the slag chute. When the raw materials are added to the feed hopper and pressurized under the screw, the squeezed juice flows into the juice rack at the bottom through the filter screen, while the waste is discharged through the annular gap formed between the screw and the conical part of the pressure adjustment, and the size of the gap can be adjusted by moving the pressure adjustment head along the axis. Use it in a clockwise direction (from the equipment slag chute to the hand wheel bearing seat at the end of the feeding bucket, the pressure regulating head is on the left side, and the clearance is reduced; otherwise, the clearance is increased.) Changing the size of the gap, that is, adjusting the slag discharge resistance, can change the slag discharge rate. However, if the gap is too small, some slag particles and juice will be squeezed out with the juice through the filter screen. Although the juice has increased, the quality of the juice has declined relatively, and the size of the gap should depend on the specific technological requirements of users. So as to achieve the purpose of automatic separation of fruit juice and slag.
