1. The box part of the machine is equipped with an oil meter. All oil should be added once before starting up. It can be added in the middle according to the temperature rise and operating conditions of each bearing.
2. The worm gear box must store oil for a long time. The oil level is high enough that the worm gear invades the oil. If it is used frequently, the oil must be replaced every three months. There is an oil plug at the bottom for draining oil.
3. When the machine is refueling, don't let the oil spill out of the cup, let alone flow around the machine and on the ground. Because oil easily pollutes materials and affects product quality.
4. Check the parts regularly, once a month, check whether the worm gear, worm, bolts on the lubricating block, bearings and other movable parts are flexible and worn. If any defects are found, they should be repaired in time and should not be used reluctantly.
5. The machine should be used in a dry and clean room, and should not be used in a place where the atmosphere contains acids and other gases that are corrosive to the body.
6. After the machine is used or stopped, the rotating drum should be taken out to clean and brush the remaining powder in the bucket, and then install it, ready for the next use.
7. If the machine is out of service for a long time, the whole body of the machine must be wiped and cleaned, and the smooth surface of the machine parts should be coated with anti-rust oil and covered with a cloth canopy.