What is the cause of the blockage of the fully automatic oil press?
Automatic oil press is a machine that extrudes grease from oil by means of external mechanical force. Due to the improper operation of the factors caused by the blockage of the oil press, then what causes the blockage of the oil press?
Screen cloth oil go unilateral; If the screen surface is not horizontal, the length of the left and right boom should be adjusted to make them equal; If the screen body appears torsion pendulum, eccentric axle can be adjusted to make it perpendicular to the frame. If it is to the stone screen surface oil unilateral, can adjust the frame to make it level, if the air flow is uneven, can adjust the air adjustment plate of the bellows, so that the air flow evenly blows to the screen surface. If the sieve net rate is low, should replace the new brush or adjust the length of the brush, at the same time adjust the tilt Angle of the flat screen.
Belt grease does not lift material; The main reason is that the oil accumulation in the lower part of the conveyor of the bucket elevator is excessive, causing blockage. The lower part of the conveyor can be opened to remove the oil accumulation.
The elimination method is to loosen the adjusting bolt of the roll and remove the oil between the rollers if there is any oil between the rollers during startup. If the feeding amount is too large and the speed is too fast, the insert plate at the feeding port can be closed. If the thickness of the rolled blank material is uneven, the gap between the rolls should be readjust and the loose nut should be tightened.
