Do a good job of removing impurities and iron:Whether it is the production of pellet feed or pellets, the raw materials are often mixed with some impurities, such as sand, stones or iron. These impurities into the pellet machine, due to the strong extrusion stress and friction between them, will make the parts wear out too fast, not only reduce the formation rate of particles, increase the production cost, and directly affect the productivity.
Therefore, the raw material must do a good job of removing iron and impurities. The iron removal device must be cleaned once per shift to avoid foreign matter from entering the pellet machine, resulting in vibration and cracking of the body. Avoid overload:Some users choose to replenish materials or run continuously for 24 hours in order to pursue higher productivity. Overloading will also exacerbate the wear and tear of the pellet machine bearings. When the pellet machine is started, the amount of feed is increased from low speed to high speed, and the rotational speed is controlled. It is not allowed to run at high speed as soon as it is started, otherwise the pellet machine will be damaged or clogged due to sudden overloading.
