1. Lubrication:Lubricate the rear bearing (coupling end) every three shifts, and the front bearing once a week; use No. 3 lithium grease for lubrication. Add 20 # and 30 # diesel oil to the 180° spindle housing.
2. The bottom of the lower seat of the bearing box is equipped with an oil drain hole, which is opened every 1-2 months to discharge the waste oil.
3.1 # Adjustment of the gap between the spiral blade end (discharge end) of the impeller and the coal feed hole in the head:a, about 5 mm under normal conditions; when the coal is too wet and the current is too small, the gap should be increased to 10-20 mm.
4. Be sure to clean the coal accumulated in the machine every time you stop.
5. Before each loading head, be sure to remove the coal particles from the matching end of the head, the end edges of the material shell, and the grooves of the lock ring to ensure that the end of the head and the shell edges of the head fully install the lock ring. Any cruel handling and blind tapping is not allowed.
6. Before closing and reconnecting, be sure to remove any coal particles from the semi-mounting surface to prevent deformation of the funnel.
7. Be sure to check the accumulation of remaining material, if any, under the perforated plate gear cavity with each shift.
8. Reducer with 15-n320 long shaft lubrication or reducer reference.
9. Fluid coupling (if 200 flat oil is used or reference to the outlet, if any).
10. Be sure to check the cooling outlet of the fluid coupling regularly.
11. Main bending correction method: the main mechanism is long, individual users due to structural needs and the use of too long, the main bending method is too long, the main body of the main bending failure time is too long, the main bending step is as follows: the casing and the head for the 1), the spindle is removed, the spindle is removed, the spindle is broken, the spindle is broken, the spindle is broken, the spindle is broken, the spindle is broken, the spindle is broken, the extent of the main shaft with the proportionality of the box for measurement.
