The straw kneading machine is a forage feed processing machine integrating cutting and kneading. The following is the common detailed maintenance knowledge brought by the straw kneading machine manufacturer.
1. Shift inspection and maintenance: After each shift, the first thing is to tighten the screws, check the tightening of all bolts and nuts, and tighten them firmly
2. It is also an important job to lubricate the transmission parts. In the manual, the parts that need to be lubricated are generally marked, and sodium-based grease can be applied to these parts to make them rotate flexibly. Don't take it too hard, regular lubrication can reduce wear and tear and increase their lifespan.
3. Open the belt cover and check the tightness of the belt. The tightness of the belt of the kneading and crushing mechanism is no more than 5 cm up and down. If the belt is too loose, the position of the motor needs to be adjusted to ensure that the belt has a proper tightness.
4. When using for about a month, it is important to check the wear of the belt. If the belt is seriously worn, the belt should be replaced in time.
5. Use one to two months to check the wear of the hammers in the kneading and crushing mechanism. If the hammers are worn too much, replace the hammers in time. There is a requirement for the replacement of the hammers, that is, the weight of the four sets of hammers is To be equal, the difference should not exceed 10 points. If the weight is uneven, it will also cause the machine to shake.
6. Seasonal maintenance: After each season's work, after a comprehensive inspection of the straw rubbing machine, put it in a dry place or indoors, and cover it with a plastic sheet to prevent dust and moisture.