Disassembly and assembly sequence of wood pellet mill
Wood pellet mill is a new type of environmentally friendly energy equipment, because the future economic development trend will revolve around low-carbon environmental protection to start, after all, only environmental protection economy can be a long time to develop and grow, and wood pellet mill is to save energy, reduce environmental pollution and the birth of the wood pellet mill, but we encountered unavoidable situations when we use it should be dismantled and installed, then the dismantling of wood pellet mill is the order of what? What is the order of disassembling the wood pellet machine?
1, equipment in the production work, the operator if you find the host current is too large, the temperature of the granulation bin is too high, you should check whether the pressure roller gap changes, the gap between the pressure roller and the ring mould is increased, if you find anomalies, you should tell the maintenance worker to adjust the pressure roller gap, or adjust the gap between the pressure roller and the ring mould.
2, maintenance workers to repair the gap is too large pressure roller, found no other abnormalities, you can adjust the pressure roller gap, so that it meets the production requirements.
3, disassembly should be prepared for assembly, in order to improve assembly efficiency and ensure the correctness of the assembly, disassembly should pay attention to check and mark.
4、Disassembly should be cleared off the surface of the soil and oil before disassembly, the disassembly process should be kept clean.
5, according to the need to disassemble, as little as possible to disassemble, not allowed to disassemble the disassembly.
6, dismantling should use the appropriate tools, can not hit and knock, so as to avoid damage or deformation of the parts.
7, on the removal of the pressure roller accessories carefully checked, found that can not use the accessories, should be replaced in a timely manner.
8, the uninstalled parts with diesel fuel to clean spare parts, and then clean diesel fuel to clean again, wipe clean with a cotton cloth, put in a clean plastic bag or other clean flat objects to be used.
9, in the dismantling device, the bearing outer ring pressed into the pressure roller shell in a fixed position, and then put the bearing inner ring into, add high-temperature lubricating grease, the same way to install another bearing.
10、Assemble the high temperature resistant oil seal and card spring.
11、Assemble the anti-dust cover.
12、Adjust the gap of the pressure roller, when the gap is considered suitable and the operation is flexible, fix the compression nut and fix the card spring blade to fix the gap of the pressure roller.
Before we carry out this disassembly work on the wood pellet machine, we also need to have a detailed understanding of the instructions and principles of the equipment, because it is very important to master the correct disassembly order of the equipment, so that we can do it will not be haphazardly disassembled, resulting in all kinds of mechanical failures.
