The first common problem is that the sawdust dryer may slack, fall off, or break the belt during use or when it is used for a long time. To solve this problem, the solution is very simple, that is, always check whether each switch is in good contact, whether the fuse is blown, whether the position of the motor is correct, and often replace the belt;
The second common problem is that the sawdust dryer may suddenly become very noisy when it is in use. To solve this noisy problem, we must consider from many aspects, such as whether the placement position is unbalanced, if it is placed evenly; whether it is not installed properly during installation, if it is reinstalled for a long time, whether the bearing has lost oil or is damaged , If so, replace the bearing; are the fixing bolts of the bearing seat loose, if it is tightened for a long time, etc.;
The third common problem is that the sawdust dryer often fails to brake. This is mostly caused by excessive brake pad wear. So to solve this problem, you only need to replace the brake pads;
The fourth common problem is that the raw materials in the sawdust dryer catch fire. This is mostly caused by improper operation and use. Therefore, it is recommended that users be familiar with the operation instructions of the dryer before use, and operate according to the requirements. Of course, it is not ruled out. There is a problem with the design of the sawdust dryer itself. If it is a problem with the dryer itself, it is necessary to actively negotiate with the manufacturer and request to replace or modify the dryer;
The fifth common problem is that the material in the sawdust dryer cannot be sucked away. This is likely to be a problem during installation, air leakage, etc., to solve this problem is to determine the cause and solve it correctly according to the cause.