1. The adjustment of the wheelbase is based on the different installation positions on the rotating shaft according to the number of driving wheels. There will be five different wheelbases. According to different working regulations, different wheelbases can be adjusted, and the wheelbase can be adjusted to 700Mm during work.
2. In the case of heat sealing, the air pocket is topped up, and the air in the packaging bag is not cleaned, so there will be no vacuum packaging after the air is deflated.
3. The function of the air bag is to inflate. Because there is a certain gap between the empty bag and the upper silicone rubber during the vacuum packaging work, there must be no gap when heating, so the air bag will heat up Put it on top, make it stick to the top and then heat it up.
4. The deviation of the equipment transmission belt will result in uneven forward speed of the equipment. At this time, the surface of the transmission belt or transmission chain will be stained with oil. After shutting down, wash it with a clean cloth.
5. The clutch is slipping or hot, and the moving speed is very slow. It may be that the surface of the friction sheet is stained with oil. The clutch should be removed and cleaned with gasoline. Sometimes the device does not move or there is friction, indicating that the surface of the friction sheet is too damaged, or the clutch spring is weak or broken. At this time, the friction piece should be removed, because the equipment load is very heavy.