After the corn stover feed pellet machine is started, it will idle for 2 to 3 minutes. When there is no abnormality, the paper will be fed again. Secondly, when working, you should always pay attention to the operation of the corn stalk feed pellet machine, and the feeding should be uniform to prevent the car from being blocked, and do not overload the machine for a long time. If vibration, noise, high temperature of bearings and body, and external spraying are found, stop the machine immediately and continue working after troubleshooting. Crushed materials should be carefully inspected to avoid accidents such as copper, iron, stones and other hard objects entering the crushing chamber.
Operators of corn stover feed pellet mills should not wear gloves. When feeding, stand on the side of the corn stover feed pellet machine to prevent the rebound debris from hurting the face. The long-term operation of the machine should be fixed on the cement foundation. If the workplace is changed frequently, the corn stover feed pellet machine and motor should be mounted on a base made of angle iron. If the feed pellet machine is driven by diesel, the power of the two should be matched, that is, the power of the diesel engine is slightly larger than that of the crusher, and the pulley grooves of the two should be matched, and the outer end pulleys should be on the same plane. After installing the feed pellet machine, check the tightness of each fastener. If it is loose, it must be tightened.
Check whether the belt tension is appropriate, and whether the motor shaft and the sawdust machine shaft are parallel. Before starting the corn stover feed pellet machine, please turn the rotor by hand to check whether the teeth, hammer and rotor are running flexibly and reliably. There are no collisions in the shell. Whether the direction of the rotor is consistent with the direction shown by the arrow on the machine, the motor, and whether the lubrication of the corn stover feed pellet machine is good. Do not replace the pulley casually. If the speed is too high, the explosion chamber will explode, or the speed is too low, which will affect the work efficiency.