How to use the feed mixer

1. Fix the unit: the unit should be installed to ensure that the base of the unit is placed horizontally (if it is not level, a wooden board can be used to level it), otherwise it will easily cause the unit to vibrate.
2. Check the connecting parts, whether the bolts are loose, manual propeller shaft, check whether there is a card touch phenomenon and whether the propulsion is flexible, the crusher rotor hammer is flexible and reliable.
3. power supply, switch, wire to be insulated and reliable, easy to control, do not use the fuse or fuse with the unit supporting the motor rated current does not match. 4.5KW motor must be equipped with overload protection device.
5. Empty machine (without conformity) check the direction of rotation of the motor, the motor should rotate in the direction specified by the arrow on the label, otherwise there is a risk of damage to the machine, if the direction is not correct, you can swap any two joints of the motor position.
6. Check the tightening of each transmission belt (the motor can move left and right, AB impeller can move back and forth) to make it suitable.
7. Check the feeding pipe, mixing machine on each connection part of the phenomenon of leakage of powder, from the observation hole to see the main hopper and propeller inside the debris, if not, it is normal.
8. Prepare feed one machine bin for one batch. Weigh out the materials needed to mix the feed. First start the mixing motor, then start the crushing motor (otherwise stuck impeller, burn the motor), feed from the secondary hopper does not need to crush materials, fried rice cake crusher to join the need to crush materials, both sides at the same time, until the main and secondary materials are all processed and then continue to mix 5-10 minutes that completes a cycle, the finished product bagged, and then the next batch of production. Note: add a small amount of raw materials must be expanded step by step
9. To remove debris, metal, sand and gravel from the material in time to avoid damage to the machine parts
10. feed mixer wear parts mainly include dynamic blade, churning dragon, material box, wearing parts also include oil seal, conveyor belt (scraper), chain, bearings, etc. PTO connection shaft should be often coated with lubricant, according to the blade wear, the need to adjust the blade direction or replace the new blade in a timely manner, often pay attention to the chain tension, timely adjustment, and often filled with lubricant. Machine work to avoid excessive mixing of forage, control the machine running time, reduce unnecessary fuel consumption, thus saving the annual operating costs of the machine. Also pay attention to the tractor's daily maintenance, timely replacement of oil and replace the steering filter, air filter, diesel filter, etc..