When the feed pellet machine equipment works for a long time, some malfunctions will inevitably occur. Below we will do some simple analysis of the feed pellet machine equipment so that everyone can better know how to solve these problems and realize the feed pellet machine. Rapid development of equipment.
| Model | Power | Capacity (kg/h) | Dimension(mm) | Weight |
| MK-120 | 3KW | 80-100 | 750*310*620 | 100 kg |
| MK-150 | 4KW | 150-200 | 770*340*680 | 115 kg |
| MK-210 | 7.5KW | 220-300 | 1000*430*950 | 210 kg |
| MK-260 | 15KW | 400-500 | 1200*500*1030 | 370 kg |
| MK-300 | 22KW | 600-700 | 1320*530*1070 | 480 kg |
| MK-360 | 22KW | 800-1000 | 1600*670*1450 | 800 kg |
| MK-400 | 30 KW | 1200-1500 | 1600*800*1700 | 1000 kg |
The output of the feed pellet machine is too low or even does not produce pellets or produces a lot of powder. Although this problem does not occur often, if it occurs, it means that the pressure wheel and grinding disc are not ground properly during the grinding process of the pellet machine, which may occur. The reason for similar problems is that the grinding hole finish of the grinding disc is poor for the first time. After grinding the grinding disc with abrasives or after using it for a period of time, the output of the pellet machine will reach the normal output. Failure to control the moisture content of the feed will also affect the output of the pellet machine. The moisture in the raw materials should be controlled at 13%-20%. Because the pellet machine has a drying and aging function, the moisture in the raw materials will be lost during the pressing process of the pellet machine. The dried pellets pressed out by the pellet machine can be bagged after drying in the shade for 5-10 minutes at room temperature.
The gap between the pressure wheel and the grinding plate of the pellet machine is too large, which may also be one of the reasons why the pellet machine does not discharge material. To adjust the gap between the pressure wheel and the grinding plate, twist the pressure wheel with one hand, adjust the corresponding bolts, and adjust to both sides. If the pressure wheel cannot shake with force and is slightly tight, it means that the pressure wheel and grinding disc have been adjusted in place. In addition, the feed pellet machine for breeding that has just been received will not reach the normal output. This is a normal phenomenon because the pellet machines are all new machines. The pellet machine that has just been run has not reached the ideal operating condition. The machine will be used for a period of time. After some time, after all parts of the pellet machine have been run-in to the ideal state, the output and discharge quality of the pellet machine will reach the rated output state.
Our packaging
