First, the granule unit should be used in a dry room and not in the place where corrosive gases such as acids are circulating in the atmosphere.
Second, regular inspection of the machine parts to see if it works normally, once a month, the inspection includes the worm wheel, worm gear, lubricating block on the bolts, bearings and other movable parts of the rotation of flexible and wear, and defects found should be repaired in time, no longer continue to use.
Third, after the granule unit is used or when it stops, the rotating drum should be taken out for cleaning and brushing the remaining powder in the bucket (only for some granule units), and then installed properly to prepare for the next use.
Fourth, when the drum twitches back and forth during work, the M10 screw on the front bearing pawn should be adjusted to the proper position. If the gear shaft twitches, please adjust the M10 screw on the back of the bearing frame to the appropriate position, adjust the clearance to the bearing does not ring, hand turn the belt pulley, the appropriate tension is better, if too tight or too loose may cause damage to the machine.
V. If the machine is out of use for a long time, the whole body of the granule unit must be wiped and cleaned, and the bright surface of the machine parts should be coated with anti-rust oil and covered with a cloth canopy.
As long as you do the above work, you can greatly reduce the failure of the pellet mill, so that the efficiency of the pellet mill to the highest level.