1. The wood pellet unit should be used in a dry room, and cannot be used in places where there are corrosive gases such as acids in the atmosphere.
2. Regularly check the parts to see if the work is normal, and check once a month. The inspection content includes whether the worm gear, the bolts on the worm lubricating block, the bearing and other moving parts are flexible and worn. If defects are found, they should be repaired in time and no longer continue. use.
3. After the sawdust pellet unit is used or stopped, the rotating drum should be taken out to clean and brush the remaining powder in the bucket (only for certain pellet units), and then install it properly to prepare for the next use.
4. When the drum moves back and forth during work, adjust the screws on the front bearing to the proper position. If the gear shaft moves, please adjust the screws on the back of the bearing frame to the proper position, adjust the clearance so that the bearing does not make noise, turn the pulley by hand, and the tightness is appropriate. If it is too tight or too loose, the machine may be damaged.
5. If the stoppage time is too long, the whole body of the pellet unit must be wiped clean, and the smooth surface of the machine parts should be coated with anti-rust oil and covered with a cloth awning.