How to use the wood pellet machine correctly? The compression ratio of the sawdust die is the ratio of the reasonable length of the ring die hole to the minimum diameter of the ring die hole, and is an indicator of the extrusion strength of the sawdust pellets. The wood pellet machine is a production-type machine that crushes eucalyptus, pine, birch, poplar, fruit wood, crop straw and bamboo chips into sawdust and chaff to process into biomass fuel. The new generation of sawdust pellet machine effectively solves the shortcomings of difficult to pellet biological crude fiber and poor effect. The material is uniform, the door cover is equipped with a forced feeder, and the international advanced manufacturing process is adopted to customize high-quality molds for various raw materials for your various pellet machines, so as to prolong the life of your equipment, improve product quality, and reduce consumption per ton. Fees drop. The biomass pellet function uses the wastes of agricultural and forestry processing such as wood chips, straw, rice husk, bark and other biomass as raw materials, and through pretreatment and processing, it is solidified into high-density pellet fuel, which is an ideal fuel to replace kerosene.
The straw pellet machine absorbs the essence of domestic and foreign pellet machines and is a new energy-saving product. In the past, feed was generally processed into powder and then fed, which had defects such as inconvenient feeding, poor palatability, picky eaters by livestock, and low utilization rate. The higher the compression ratio, the stronger the extruded wood pellets. According to the compression ratio of the straight hole ring die, the reasonable length of the ring die hole is the total thickness of the ring die, and the smallest diameter is the diameter of the die hole itself. For the demolding step hole and the outer taper hole, the reasonable length of the die hole is the total thickness of the ring die minus the length of the discharge hole or the length of the outer taper hole, and the diameter of the small diameter section is the diameter of the compression ratio. For compression stepped bores and inner tapered bores, this situation is quite A. Generally, the thickness of the entire ring die is taken as the reasonable length of the die hole, and the diameter of the small diameter section is taken as the diameter of the small diameter section. In this case, the ring-mode compression ratio calculated by this method has a different meaning than the first two cases. The current of the sawdust pellet machine meets the specified load control, and it is absolutely not allowed to overload the production for a long time, which is the key reason for the damage of the facility. In the whole process, it is necessary to ensure that the sawdust pellet machine can perform its better production when it is close to overload operation. When the sawdust pellet machine is working, the feeding speed should not be too fast. After about ten minutes, the body starts to heat up so that it can eat without any problems, otherwise it will cause blockages and high temperatures.