What should I do if the biomass briquetting machine is abnormal?

                   The finished particles of the biomass briquetting machine are bent and cracked. The main reason for this phenomenon is that the position and pressure of the biomass briquetting machine cutter are not enough, and the area for processing raw materials is too large. The improved method is to use the pressure of the forming machine to improve the positional clarity of the cutting machine. The raw materials can be crushed again and processed to the appropriate fineness. There are cracks in the cross section of the finished product of the biomass briquetting machine, but they are not completely covered by the cracks. This is mainly because the raw materials contain some long particles. The improvement method is to crush the raw materials again.

                  Vertical cracks appear on the surface of the finished particles, mainly caused by the reaction between water and the principle when extruding the mold with excessive moisture. The solution is to control the moisture content of processed raw materials. The particle surface is uneven and not smooth. The direct cause of this phenomenon is that there are problems with the raw materials used for processing. There are materials with large diameter and high hardness inside. Excessive moisture content in the raw materials will cause the surface of the processed finished product to be uneven. We regularly perform maintenance on our equipment.