Tabbing And Cheap Wood Crusher

Tianjin Mikim Technique Co., Ltd. is one of the most experienced manufacturers and suppliers of tabbing and cheap wood crusher in China. If you're going to buy cheap tabbing and cheap wood crusher made in China, welcome to get more information from our factory. All our products are with high quality and low price.

The motor should be selected according to the regulations on the nameplate of the kneading machine. It is not allowed to increase the spindle speed at will, and it is not allowed to remove the protective devices of various parts at will.
When feeding materials, it is strictly forbidden to reach into the feeding hopper with your hands to feed materials. Corn stalks, etc. can be used to feed materials inward.
If abnormal noise occurs during operation, stop the machine immediately for inspection. It is prohibited to troubleshoot while the machine is running.
If it is not used for a long time, anti-rust oil should be applied to the non-painted areas.

Cleaning: Clean the feed and discharge ports regularly to prevent wood chips and impurities from clogging. Use compressed air or a soft brush to remove dust and debris inside and outside the machine, especially around the blades, bearings and motors. Check and clean the vents to ensure good heat dissipation.
Lubrication check: Check and replace the lubricating oil or grease regularly to ensure that all parts that need lubrication (such as bearings, gears, etc.) are fully lubricated. Note that the choice of lubricating oil should be in accordance with the manufacturer's recommendations.
Fastener check: Check all screws, nuts and fasteners for looseness. If they are loose, tighten them immediately. Ensure that the tension of the drive belt or chain is appropriate to avoid over-tightening or over-loosening.

Qualifications and Honors

Hot Tags: tabbing and cheap wood crusher, China, manufacturers, factory, cheap, low price, made in China