Lowest Noise Tooth And Claw Crusher

Tianjin Mikim Technique Co., Ltd. is one of the most experienced manufacturers and suppliers of lowest noise tooth and claw crusher in China. If you're going to buy cheap lowest noise tooth and claw crusher made in China, welcome to get more information from our factory. All our products are with high quality and low price.

During the production and operation of the pulverizer, the pulverizer motor drives the main shaft and turbine to rotate at high speed, and the speed can reach up to 700r/min. The turbine and the grinding block on the screen ring form a crushing and grinding pair, and its structure is compact. When the material enters the machine cavity from the hopper, the material entering the machine cavity is closely rubbed and strongly impacted in the rotating air flow to the inner edge of the turbine blade, and is ground again in the gap between the blade and the grinding block.

Method of filling lubricating oil
The method of filling lubricating oil is also very important. Generally speaking, you should stop the machine first, then find the filling port. Before filling, make sure that the type and brand of the added oil are consistent with the original oil, and confirm the oil level of the lubricating oil.
When filling, the amount should be appropriate, not too much or too little. Too much will increase the oil pressure and cause the bearing to deform; too little will lack lubrication and increase bearing wear.
In addition to filling lubricating oil, it is also necessary to replace the lubricating oil regularly. According to the use time or workload of the machine, the lubricating oil is usually replaced every six months or every year.
Other maintenance precautions
In addition to paying attention to filling lubricating oil, there are other maintenance precautions. For example, before the crusher is operated, check whether all parts are complete and the connection is firm; pay attention to the sound during operation and observe whether the vibration is normal; after use, clean the inside of the crusher to ensure that no debris is left to prevent the next use.
In short, the maintenance of the crusher bearing requires regular maintenance, and pay attention to the timing and method of filling lubricating oil. Only by doing these basic work can the efficient operation of the machine be guaranteed and the service life of the machine be extended.

Customer visit

Hot Tags: lowest noise tooth and claw crusher, China, manufacturers, factory, cheap, low price, made in China