Inimitable Rod Making Machine

Tianjin Mikim Technique Co., Ltd. is one of the most experienced manufacturers and suppliers of inimitable rod making machine in China. If you're going to buy cheap inimitable rod making machine made in China, welcome to get more information from our factory. All our products are with high quality and low price.

This product has high density, small size and good flammability, and can replace firewood and coal. Generally, the outer diameter of the product is 50-60mm, the aperture is 15-20mm, and it is in the shape of a hollow square or hexagonal cylinder. It can also be made into spherical, granular and honeycomb shapes.

Preparation before starting
Check the equipment: Make sure that all parts of the rod making machine are intact, such as checking whether the forming cylinder, spiral propeller, etc. are damaged or deformed, and whether the connection parts are tight.
Clean the equipment: Clean the debris, dust, etc. inside and around the rod making machine to keep the equipment clean and tidy.
Prepare the raw materials: Crush the required raw materials (such as sawdust, wood chips, straw, etc.) to make their particle size meet the requirements of the rod making machine, generally 3-5 mm. At the same time, the humidity of the raw materials should be controlled, usually between 8%-12%.
Add lubricating oil: Add an appropriate amount of lubricating oil to the specified parts according to the requirements of the equipment manual to ensure smooth operation of the equipment.
Connect the power supply: Connect the rod making machine to the power supply correctly and ensure that the power supply voltage is stable.
Start the equipment: Turn on the power switch of the rod making machine and start the equipment.
Preheating: Let the rod making machine idle for a period of time to preheat so that the equipment reaches a suitable working temperature. The preheating time depends on the equipment model and ambient temperature, generally 10-15 minutes.
Adjust parameters (some equipment has this step): According to the characteristics of the raw materials and the specifications of the required charcoal sticks, adjust the relevant parameters of the stick making machine, such as pressure, temperature, speed, etc. Feeding and stick making
Uniform feeding: After the equipment is preheated, start to evenly feed the prepared raw materials into the feeding port of the stick making machine. Be careful not to feed too much at one time to avoid blockage.
Observe the stick making situation: During the stick making process, closely observe the forming of the charcoal sticks, including the density, hardness, surface smoothness, etc. of the sticks. If problems are found, such as loose and unformed sticks, adjust the humidity, particle size or equipment parameters of the raw materials in time.
Collecting firewood sticks: Take the finished firewood sticks out of the discharge port of the stick making machine and place them neatly aside or on the conveyor belt for subsequent processing (such as carbonization).

Qualifications and Honors

Hot Tags: inimitable rod making machine, China, manufacturers, factory, cheap, low price, made in China, Untouchable Rod Making Machine, Charcoal Stick Extruder, Charcoal Rod Extruder, Coal Bar Briquette Machine, Charcoal Extruder Machine, Coal Sticks Extruder